Network Design and Activation Fiber to The Building (FTTB) and Measurement of The Damage Value of Optical Distribution Frame (ODF) To Optical Distribution Cabinet (ODC)
DOI:
https://doi.org/10.62671/jataed.v2i2.70Keywords:
Fiber to The Building; attenuation; Optical Distribution Frame; Optical Distribution Cabinet.Abstract
The need for high-speed internet continues to increase with technological developments. Fiber to the Building (FTTB) is a solution for providing fast internet access to commercial and residential buildings. However, the main challenge in maintaining network quality is attenuation in fiber optic cables, especially at connections. This research aims to analyze the effect of pigtail cable length and connection quality on the total attenuation from the Optical Distribution Frame (ODF) to the Optical Distribution Cabinet (ODC) in the FTTB network, both before and after activation. The research method uses pigtail cables of varying lengths, from 30 cm to 150 cm. Some connections are carried out according to Standard Operating Procedures (SOP), while others are not, to measure the effect of connection quality on attenuation. Measurements were carried out using an Optical Power Meter (OPM) and Passive Optical Network (PON) technology with an SFP of 8 dB. The research results show that connections that comply with the SOP produce lower attenuation, namely 7.16 dB on a 150 cm cable, 7.09 dB on a 120 cm cable, and 6.99 dB on a 100 cm cable. On the other hand, connections that do not comply with the SOP produce higher attenuation, namely 8.15 dB on an 80 cm cable, 8.08 dB on a 50 cm cable, and 8.02 dB on a 30 cm cable. This research contributes to the optimization of FTTB network installations.
References
Agus Priyanto, “Analisis Redaman Pada Jaringan Fiber Optik DenganMetode Link Power Budget Pada Pt. Biznet,” Prosiding, vol. 2, no., pp. 130–144, 2022, doi: 10.59134/prosidng.v2i-.121.
Albar, R., & Rizki, Z. M. (2020). Analisa Pengaruh Teknik Splice Mekanik dan Splice Fusion Fiber Optik Terhadap Redaman (dB) Pada PT. Telkom Indonesia Regional I Witel-Aceh. Journal of Informatics and ComputerScience, 6(2), 74–79.
Asril, A. A., Yolanda, A., Lifwarda, -, Putri, D. K., & Kasmar, A. F. (2022). Design Attention System of Single Mode Aerial Fiber Optic Cable Transmission on Connection Loss on Passive Splitter. International Journal of Advanced Science Computing and Engineering, 4(1). https://doi.org/10.30630/ijasce.4.1.74
Aulia, H. Z., & Garniwa, I. (2023). Analysis of ICONNET Fiber optic Network Improvement in Cluster Rayon Panam at Strategic Business Unit Central Sumatra PT PLN ICON PLUS. Jurnal Pendidikan Teknologi Kejuruan, 6(2),149–155. https://doi.org/10.24036/jptk.v6i2.33723
A. Nur Fajrina, T. Nopiani Damayanti, and R. Maulana, “Perancangan Jaringan Fiber to The Building (FTTB) Berbasis GPON (Gigabit Passive Optical Network) Di Apartemen Taman Melati Rancaekek,” e-Proceeding of Applied Science, vol. 9, no. 1, pp. 176–186, 2023.
D. Kiycioglu and N. O. Unverdi, “Applications of FTTX technology in optical communication systems [Optik Haberlesme Sistemlerinde FTTX Teknolojisi Uygulamalari],” 26th IEEE Signal Process. Commun. Appl. Conf. SIU 2018, pp.1–4,2018.
IEC 61746, “Calibration of Optical Time Domain Reflectometer (OTDR),” International Electrotechnical Commission.
ISO/IEE 14763-3,” Information Technology-Implementation and Operation of Customer Premises Cabling-Part 3: Testing of Optical Fibre Cabling.”International Organization for Standardization”.
K. Wang et al., “Techno-economic analysis of active optical network migration toward next-generation optical access,” J. Opt. Commun. Netw., vol. 9, no.4, pp. 327–341, 2017, doi: 10.1364/JOCN.9.000327.
Mardhatillah, K., A. A. Asril, and Y. Yulindon, “Analisa Rugi-Rugi Sambungan Kabel Drop Core Terhadap Performansi Jaringan Optik Di Gedung G Lantai 3 Politeknik Negeri Padang,” J. Fokus Elektroda …, vol. 07, no. 03, pp. 172–177,2022.
Maslo, A., Telecom, B. H., & Goran, N. (2020). A practical analysis of attenuationin segment of home installation of FTTH networks.
M. Holik, T. Horvath, and V. Oujezsky, “Application for GPON frameanalysis,” Electron., vol. 8, no. 6, 2019, doi: 10.3390/electronics8060700.
Octavia, H., Asril, A. A., Veronica, V., & Khairunnisa, S. (2019). Design of a Transmission Mution Measurement System in Single Mode Cable IndexandMulti Step Index Step Optical Models Due to Bending Data Factors with Fingers Using OPM and OTDR Measurement Equipment. Jurnal Ilmiah Poli Rekayasa, 15(1), 27. doi:10.30630/jipr.15.1.135.
R. Albar and Z. M. Rizki, “Analisa Pengaruh Teknik Splice Mekanik dan Splice Fusion Fiber Optik Terhadap Redaman (dB) Pada PT. Telkom Indonesia Regional I Witel-Aceh,” J. Informatics Comput. Sci., vol. 6, no. 2, pp. 74– 79, 2020.
R. Hafizt, Yustini, A. A. Asril, H. N. Nawi and A. Warman, ""Implementasi dan Perfomansi Jaringan Fiber to The Home dengan Teknologi GPON","Jurnal Teknologi Elekterika, vol. 18 (2), pp. 53-58, 2021.
Siswanto, O. U. (2005). Analisis Perhitungan Rugi-Rugi Pada Serat Optik. Jurnal Teknik Elektro Universitas Diponegoro, 1–10.
S. Serecunova, D. Seyringer, F. Uherek, and H. Seyringer, “Waveguide shape and waveguide core size optimization of Y-branch optical splitters up to 128 splitting ratio”, Opt. Commun., vol. 501, no. July, p. 127362, 2021, doi: 10.1016/j.optcom.2021.127362
Wibisono Gunawan, Hantoro Dwi Gunadi, F. (2020). Sistem Jaringan Fiber Optic.
Z. Cui, S. Member, and C. Yuan, “Modeling the splice loss of single-mode optical fibers affected by altitude,” IEEE Access, vol. PP, p. 1, 2019, doi:10.1109/ACCESS.2019.2927395.
Downloads
Published
Issue
Section
License
Copyright (c) 2025 Eka Safitri, Aprinal Adila Asril, Rikki Vitria
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
